MULTI-TASKING VEHICLE DESIGN


This design will be ideal for fire suppression, large prescribed burns, and backburning, as the bed
above the tank will allow for storage of approximately 300 - 400 lbs of gear/drip torches/fuel cans, etc.
(depending on the set-up of the skid unit) while still hauling 100 gallons of water.  Equipped with a
CAFS unit, this unit can provide some serious fire suppression capabilities.  
The skid unit can quickly be removed to perform Search and Rescue, haul equipment and supplies, etc.
 Please feel free to give us a call with any questions or recommendations you may have concerning
your next off-road firefighting vehicle.

Vehicle
Specifications

Request
Information

Home

Contact Us

Photo Gallery

                 NEW DESIGN – MULTI-TASKING VEHICLE

Vehicle:
WASP Firefighting/Utility Combination Vehicle

Full time 4 wheel drive, center articulated vehicle. The fiberglass shall be red, and the unit shall have
the following:
      Brush Cage and Flat Bed
      Protective shield for gas tank
      Front skid plate
      Relocated exhaust and muffler
      
      100 Gallon T- Tank – The tank shall be securely fastened to the rear sectional frame, and will
have a 10” fill tower, two sight glass (water level) inserts on the front of tank, a 2” quick dump fitting
on the rear of the tank. A 2” dip tube for feed to pump with a small sump in bottom of tank. The tank
configuration shall be constructed in such a way as the bulk of the weight shall be located directly
over the vehicle frame and shall be centered over rear axle. The tank shall be securely fastened to
the frame of the vehicle with a minimum of four each ½” bolts.

      The Flat Bed shall be constructed and mounted over the top of the 100 Gallon T- Tank. The
stanchions for the bed shall also aid in the retention of the tank. The bed shall measure 48” wide X
60” long. The bed height shall be approximately 39” above ground level. Hinged bed rails will be 10”
in height. The rails shall be constructed to facilitate the lowering of each section of rail similar to a
tailgate.

      Skid Unit shall be constructed and shall provide a means for adding and removing the pump
and/or hose reel and/or foam system onto the flat bed quickly. The skid unit shall slide under clips in
the front of bed and shall be retained with pins at the rear of bed. The skid shall also be configured
with quick connect hose fittings for tank water tie in.

We believe this package offers the best combination of functional equipment at a reasonable price.  
Our goal is to deliver a vehicle that will provide a fire department/company every possible advantage
in battling fires and performing important tasks as efficiently as possible.  If you would like to modify
the equipment in any way, please let me know.

Thank you for the opportunity to provide you this proposal.
Sloan Gorman
President
Diamond G Concepts, LLC
281-541-8747